Current exhibitor list IWA OutdoorClassics 2023
Many exhibitors have already registered for IWA OutdoorClassics 2023. All registered exhibitors can be found in the current exhibitor list:
The exhibitor & product database shows all exhibitors who were registered for IWA OutdoorClassics 2022. All information about the exhibitors & products of IWA OutdoorClassics 2023 can be found here from the middle of December.
Striking bullets penetrate a thermoplastic backing layer and are safely slowed down by a granulate material filling behind it. The canal originated by the bullet uses itself almost completely up on account of the high elasticity of the backing layer.
The bullet trap system Thermowall consists of a 100-mm-thick Backing layer by standard and chamber system which rejuvenates upwards. The depth of the chamber system is dependent on the bullet energy. For example, a bullet trap for a bullet energy of up to 1500 joules shows a whole construction depth of 550 mm. With higher bullet energy the construction depth increases accordingly. In width and height the bullet trap can be produced in the individually desired dimensions. As a location outdoor and indoor shooting ranges are possible, because the bullet trap system was developed for operation in temperature ranging from -24 ° C to + 60 ° C. Besides, no noise and dust emissions originate while bullets are striking, which is why the bullet trap system does justice to the demands of the environment protection for outdoor ranges in particular.
The 100-mm-backing layer by standard consists of an especially adjusted Copolymerise which shows an excellent restoration capability. Normally blocks are produced in the size of approx. 445 mm by 445 mm which form the backing layer lined up smoothly together without gap. Worn blocks can be recycled completely by a sophisticated recycling procedure and be processed to new blocks.
Vertical ribs combine into a firm grid cell system in connection with a back wall. Preferred materials are mainly 5-mm highly wear-resistant special steels, so-called "wear plates", as for example Hardox 500. 100-mm-ashlar-shaped blocks are lined up in and about one another without joint in front of this chamber system and are fortified on the back side. In addition, the joints are treated thermally on the front side, so that a closed backing layer originates. In the cavity between the ribs, the back wall and the backing layer a special granulate filling to reduce the energy of the bullets is introduced in which the bullets remain up to the next servicing.
Striking bullets are slowed down in the granulate filling and remain here until the next servicing. This obviously generates an enlargement of volume behind the backing layer. Due to the increasing volume of the granulate material and bullet mixture the backing layer is pressed forward and forms a "belly". When the maximum capacity is reached the push joints of the backing layer burst bit by bit, so that sporadically granulate material escapes. By no later than now a servicing must be carried out. This can be carried out by our experienced servicing team or your own staff. On this occasion, a part of the backing layer is dismantled and worn blocks are exchanged for new respectively recycled blocks. The granulate material is separated nearly without loss from the bullets and is filled in the chamber system for further use, once the backing layer has been rebuilt